pool liner installation

Liner issues and problems installing or maintaining above ground swimming pools.

pool liner installation

Postby rmvendor » Mon 14 Mar, 2005 07:36

I have a problem. I purchased a 30' round pool online for the kids for Christmas in December. I'm just installing it now.My problem is when I installed the beaded liner and started adding water to the pool the liner had so much tension on it that it started to buckle the walls.I followed the directions. I would like to know if anyone knows what the measurment should be between the sand bed/cove and the track that holds the beaded liner? I have a 52" wall.

Thanks
rmvendor
 

Above ground pool

Postby Pool Guy » Tue 15 Mar, 2005 03:02

What pool did you get? Perhaps the thing to do is contact the manufacturers. If you mess up (as I did a couple years back), they will not cover the guarantee.
Pool Guy
 

Liner shrinkage

Postby JohnK » Thu 21 Apr, 2005 09:56

I had a new 15ft liner in store for a year. Never out of the box. Tried to fit it...the floor to wall seam on one side to the other is 13'7" and it will never fit. Total waste of money to Swimline as they only cover seam failure, not dimensions changes. Be warned!
JohnK
 

Postby doubled1 » Tue 10 May, 2005 18:23

A small amount of buckling is to be expected.As the water rises the liner will stretch and the wall will go back in place.You must have a warm,sunny day to install a beaded liner.
doubled1
 

Postby fysh » Thu 19 May, 2005 14:14

The wall cove should be about 6" up the wall (2" bottom and 4" cove). If you have a 52" wall, you should have about 46" left. So your overlap liner will be more that 46" in order to overlap, stretch and stay in place. If you have a beaded liner, it should be closer to 46".
fysh
Pool Enthusiast
Pool Enthusiast
 
Posts: 11
Joined: May 2005

Pool liner tesion

Postby TonyM » Mon 27 Mar, 2006 15:00

I am having the same problem "rmvendor" had on March 14th 2005.
In my case I purchased the manufactured foam cove, so there is not much I can do about the distance from the top of the pool to the top of the cove. The pool ia also a 30 foot diameter pool but I have a "J-hook" liner. I currently have about 5 inches of water in the pool. The liner is bowing tightly inward like a sail creating a 1-2 inch gap between the liner and the pool wall. I can reach in the pool and push the liner back towards the wall but it feels like I am pushing on a balloon. Is this normal? will the liner stretch? Should I wait for a sunny day to continue filling?
TonyM
 

liner probs

Postby dood » Mon 27 Mar, 2006 16:46

I had the same darn issue 2 years back. Was told to wait for a hot day and fill. I did so but still took a few weeks for the liner to strech enough to fill the gap.
dood
 

liner stretch

Postby New 2b pool user » Sat 15 Apr, 2006 10:19

So even if the day is warm and liner is "relaxed" before filling starts, if in fact the water is very cold the effect will be the same - liner not stretching until the water warms up? We also purchased a J Hook with an 18x33 so how much buckle or bend in the wall is expected?

We will be depending on a solar panel set from day one to get the water warmed. Is there any benefit to trying to run the initial fill through the solar panels some way to get a start on the warming? Our water will come from a well (54 deg F) as we are rural and there is no way to get water from any other source (50 miles to town, the delivery of over 19,000 gallons with mileage fees would be prohibitive)
New 2b pool user
 

Solar heat question

Postby Roxi » Sat 15 Apr, 2006 18:57

Is there any benefit to trying to run the initial fill through the solar panels some way to get a start on the warming?

Trying to run that volume of water through the solar panels would not be good for the panels.
Pump straight into the pool and get the heating on as soon as there is enough water to run the pool pump. The water will heat up from the sun, solar system and ambient air temperature within a few days.
Roxi
 

Postby hrsdennis » Tue 18 Apr, 2006 20:36

It is really amazing how much a liner will stretch. The key is to fill the pool only when the sun is directly overhead. Sunshine is far more important than water temperature.

Best of luck, Dennis
AG Pool builder for 35 years
hrsdennis
Pool Enthusiast
Pool Enthusiast
 
Posts: 10
Joined: April 2006
Location: Arizona

[Show] Post a reply

Next

Return to Liner & Above Ground Pools


Pool Maintenance   •   Pool Wizard   •   Pool Help   •   Havuz Bakımı